The power supply unit (PSU) in a PC regulates and delivers the power to the components in the case.
--------------------------------------------------------------------------------
Power Supplies contain dangerous voltages and should only be opened by experienced and qualified engineers, there are no user servicable parts inside.
Always disconnect the PSU from the mains supply before removing the cover of the PC.
--------------------------------------------------------------------------------
Standard power supplies turn the incoming 110V or 220V AC (Alternating Current) into various DC (Direct Current) voltages suitable for powering the computer's components.
Power supplies are quoted as having a certain power output specified in Watts, a standard power supply would typically be able to deliver around 350 Watts.
The more components (hard drives, CD/DVD drives, tape drives, ventilation fans, etc) you have in your PC the greater the power required from the power supply.
By using a PSU that delivers more power than required means it won't be running at full capacity, which can prolong life by reducing heat damage to the PSU's internal components during long periods of use.
Always replace a power supply with an equivalent or superior power output (Wattage).
There are 3 types of power supply in common use:
AT Power Supply - still in use in older PCs.
ATX Power Supply - commonly in use today.
ATX-2 Power Supply - recently new standard.
The voltages produced by AT/ATX/ATX-2 power supplies are:
+3.3 Volts DC (ATX/ATX-2)
+5 Volts DC (AT/ATX/ATX-2)
-5 Volts DC (AT/ATX/ATX-2)
+5 Volts DC Standby (ATX/ATX-2)
+12 Volts DC (AT/ATX/ATX-2)
-12 Volts DC (AT/ATX/ATX-2)
A power supply can be easily changed and are generally not expensive, so if one fails (which is far from uncommon) then replacement is usually the most economic solution.
--------------------------------------------------------------------------------
back to top | © Copyright 2001-2008 helpwithpcs.com
--------------------------------------------------------------------------------
The power supply connectors
4 Pin Berg Connector
Used to connect the PSU to small form factor devices, such as 3.5" floppy drives.
available in: AT, ATX & ATX-2
4 Pin Molex Connector
This is used to power various components, including hard drives and optical drives.
available in: AT, ATX & ATX-2
20 Pin Molex ATX Power Connector
This is used to power the motherboard in ATX systems.
available in: ATX( ATX-2 have four extra pins)
4 Pin Molex P4 12V Power Connector
Used specifically for Pentium 4 Processor Motherboards.
available in: ATX (integrated into the power connector in ATX-2)
6 Pin AUX Connector
Provides +5V DC, and two connections of +3.3V.
available in: ATX/ATX-2
--------------------------------------------------------------------------------
back to top | © Copyright 2001-2008 helpwithpcs.com
--------------------------------------------------------------------------------
ATX Power Supply Pinouts
Below are pinout diagrams of the common connectors in ATX power supplies.
note: The pinouts above relate to the connectors not the sockets.
note: To power up an ATX or ATX-2 PSU for testing, short pin 14 (PS_ON) with one of the grounds.
No comments:
Post a Comment